Remote Control Mains Switch

As the only electronics engineer in my  =family and circle of friends, it is some-times not possible to evade an appeal for help. This time the request came from a friendly elderly lady in a retirement home. In her room the light switch by the door  and the pull cord above the bed operate the light fitting on the ceiling in the middle of the room. However, she would prefer that her standing lamp was operated  by these switches instead, since she does not actually have a light fitting mounted  on the ceiling. This standing lamp has an  on/of f switch in the power cord and is  plugged into a power point.

However, it  stands rather far from the bed so that she  always has to find her way in the dark. A  wireless operated power point is not really  a consideration, because it is just a matter of time before the remote is lost. Or maybe not?

Remote Control Mains Switch Circuit Diagram:

Switch Circuit Diagram


Behold a feasible circuit. Buy a wireless power point and an enclosure that is big enough for the remote control and a small piece of prototyping board. On the proto-typing board build the circuit according to the accompanying schematic and (care-fully) open the remote control and solder wires to the push buttons for ‘on’ and ‘off’.  Measure if these are polarised and if that is  the case connect them to the 4N25 opto-couplers as shown in the schematic, where  pin 5 has a higher voltage than pin 4.

The operation is as follows. The lady operates the pull cord or light switch to turn the light on. This causes the mains voltage to be applied to the transformer. The relay is activated which charges C1. While C1 charges, a small current flows through optocoupler 1. The result is that the ‘on’ button on the remote control is pressed.  The remote control switches the corresponding power point on and to which the  standing lamp is connected. The standing  lamp will therefore now turn on. Capacitor C2 is charged at the same time. If the lady pulls the cord again, or if she operates the  switch near the door, the relay will de-energise and C2 discharges across optocoupler  #2. This operates the ‘off’ contact of the  remote control and the light goes out.

The remote control continuous to operate from its normal battery and the white enclosure is attached to the ceiling in place of the light fitting. Diode D1 ensures that C1 is discharged when the relay de-energises. D2 ensures that C2 cannot discharge across the relay, but only across optocoupler 2.

Author : Jaap van der Graaff - Copyright :Elektor
 

0 comments:

Post a Comment