Brake Lights Monitor

The circuit described below monitors your car's  brake lights, and indicates by a light emiting diode  whether they both function correctly. In that sense, it can save you money by preventing your being fined for driving with defective brake lights, and it also leads to increasing road safety.

Brake Lights Monitor Circuit Diagram:

Light Circuit Diagram 
The monitor depends inevitably on the voltage drop across the supply lines to the two lamps. For the circuit to work correctly, that drop needs to be greater than 0.6 V. If this is not so, the drop must be increased by adding a 5 V diode in series with each lamp. Transistor Ti and T2 in figure 1 form a  Schmitt trigger, which reacts to the voltage drop across the supply lines to the two brake lights. This reaction manifests itself in Di lighting via T3. If  one of the brake lights is faulty, the switch-on cur- rent drawn by the other lamp will cause Di to light  briefly when the brake pedal is pressed. If both  brake lights are defective, Di will not light at all.  All three possible states of the brake lights are thus  indicated.

The hysteresis of the trigger, and, therefore, the sensitivity of the circuit, can be adjusted within narrow limits with Pi. The preset is best adjusted with one lamp out of action in a manner which makes Di light briefly as described above.

If you find it disturbing that Di lights every time  you brake, the operation can be reversed by replacing the BC557B in the T3 position by a BC547B  (n-p-n). The collector of T3 is then connected to the positive supply line, and the emitter to R6. On the printed circuit board this means that the flat edge  of T3 must be turned the other way. A second base  connection has also been provided on the PCB.  Note, however, that this configuration no longer makes it possible to ascertain whether one or both brake lights are faulty, i.e., when the LED lights, one or both lamps need replacing.

The printed circuit board is not available ready  made. In figure 1, Si is the brake pedal switch, and Lai and La2 are the brake lights.

0 comments:

Post a Comment